Cadac C-Type Manual de usuario descargar pdf (Pagina 11)

Connecting the mixer systems 1-5

Revision C2005-2 C-Type

GND and “FRAME” terminals on each frame

must

be connected. For minimum

noise, the large diameter ‘frame-link’ cables (supplied with multi-frame consoles),

must be connected. Always make sure that ‘frame-link’ cable nuts are tightened

against the copper bar.

The 0v, GND and FRAME terminals are linked in the factory with a copper bar. This

bar should never be removed when the console is in normal use. Note that

Phantom

Power

cannot be delivered from the input modules to the 48V bus if the copper bar is

missing, because the screened microphone input cables will not be terminated. It

may also cause damage to the motor faders.

*1'

)5$0(

FIG 1-6. 0V, GROUND and FRAME terminals.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 65 66

Sin comentarios

Cadac C-Type Manual de usuario Pagina 11