Cadac R-Type Manual de usuario descargar pdf (Pagina 61)

Mono Input Channel 8241 7-7

Revision R2005-2 R-Type

:14157 3$1#/HIW#0#&HQWUH#0#5LJKW

When selected, this switch overrides selection of the Centre and L-R switches. This

will route the input signal to the three main LCR outputs on the LCR module (see 10

L-C-R Output 8261) via the pan control. The PAN control then behaves in a true LCR

fashion, panning the post-fade signal from left through centre to the right outputs.

:14158

&HQWUH#VZLWFK

Routes the post-fade signal directly to the centre output of the LCR module via the

Centre level control. If the LCR switch is activated, this switch is inactive. See 7.1.26

Centre level.

/HIW#0#5LJKW#VZLWFK

Sends the post-fade signal to the main L-R outputs on the LCR module via the PAN

control, which behaves in a normal fashion, panning the signal between left and

right. See 7.1.27 PAN Control.

:14159 &HQWUH#OHYHO

This control has 6dB in hand and is centre detented at 0dB. This control is used to

set the post-fade signal level to the centre output of the LCR module if the Centre-

switch is activated. This can be used to mix or balance signal levels when the centre

output is used as a separate mono bus in conjunction with the standard L-R bus. If

the LCR switch is activated this control is inactive.

:1415: 3$1#&RQWURO

The PAN control affects 3 different sections of the module:

For the LCR sends:

The control pans the post-fade signal from Left through Centre to Right on the LCR

module master outputs. In L-R mode, the control pans the post-fade signal from Left

through Right on the LCR module master outputs without affecting the centre sends.

For the Stereo-send:

The control pans the signal between Left and Right on the PFL/Listen module stereo

outputs.

For the matrix sends and Group sends 9 -12 & 13 - 16:

The control will pan the signal between A and B group outputs as determined by

“Stereo Pan to GRPS” switch status and level setting of Aux/Group sends, and will

pan the signal between matrices 13/14 and/or 15/16 as determined by the “Stereo

Pan to MTX” switch setting and “OP to MTX” direct to matrix routing switches.

:1415; 6WHUHR

Sends the post-fade signal via the pan control to the stereo L-R outputs located on

the PFL/Listen module. This is a separate and additional stereo bus from the main

LCR outputs located on the LCR module. The LCR-switch has no effect on the oper-

ation of this additional bus.

:1415< 6WHUHR#3$1#WR#JURXSV#<#0#45

If selected, this switch will route the auxiliary/group send from the aux/group send

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 138 139

Sin comentarios

Cadac R-Type Manual de usuario Pagina 61